Hp NetRAID 1Si Controller Manual do Utilizador descarregar pdf (Página 49)

Chapter 2 HP NetRAID Assistant

d. Return to the main menu of HP NetRAID Assistant.

5. Configure this Ready disk by using the Configuration Wizard.

Reclaiming a Hot Spare

If a physical drive has been configured as a Hot Spare, you can reclaim it and

convert it to the Ready state at any time.

1. Select Configure from the main menu of HP NetRAID Assistant.

2. Select Wizard.

3. Select (highlight) the hot spare in the Logical Devices box.

4. Click the Reclaim box.

5. Use the Wizard to reconfigure this drive or accept the changes and save the

new configuration.

Changing Logical Drive Parameters

You can change the following logical drive parameters at any time:

• Cache

• Read

• Write

Changing any of these parameters does not require reconstruction of your data.

To change these logical drive parameters:

1. Click the Logical View button.

2. Select (highlight) the logical drive you want to change.

3. Choose Logical Drv from HP NetRAID Assistant’s main menu.

4. Select Change Config.

5. Change the logical drive parameters. As long as you do not change the

RAID level, your data will not be reconstructed.

Taking a Drive Offline/Online

An HP NetServer physical drive can be taken offline or put online in one of two

ways:

• You can remove or insert the disk drive by hand from an HP NetServer

hot-swap bay.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 160 161

Sem comentários

Hp NetRAID 1Si Controller Manual do Utilizador Página 49