Hp NetRAID 1Si Controller Manual do Utilizador descarregar pdf (Página 64)

Chapter 3 HP NetRAID Config

configuration information is not disturbed. For instructions on using this

selection, see "Using Easy Configuration" in this chapter.

• New Configuration also lets you create arrays and hot spares, but this

selection lets you configure spanned arrays. If you select New

Configuration, the existing configuration information on the selected

adapter is destroyed when the new configuration is saved. For instructions

on using this selection, see "Using New Configuration" in this chapter.

• View/Add/Delete Configuration lets you view an existing configuration

or configure new arrays. This selection does not disturb existing

configuration information. It does not allow you to delete configuration

information. For instructions on using this selection, see "Using View/Add

Configuration" in this chapter.

• Clear Configuration deletes the existing configuration.

Using Auto Configuration

Auto Configuration creates a configuration by following these steps:

1. Gathers drives with the same capacity into groups of five, four, or three.

These groups become arrays with RAID level 5 logical drives.

2. Gathers pairs of drives with the same capacity together. These pairs

become arrays with RAID 1 logical drives.

3. Configures any remaining single disk drives as arrays with RAID 0 logical

drives.

Auto Configuration does not create any hot spares. If you want to configure hot

spares, use the Easy Configuration or New Configuration selections.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 160 161

Sem comentários

Hp NetRAID 1Si Controller Manual do Utilizador Página 64