Hp Netserver L Server series Manual do Utilizador descarregar pdf (Página 25)

4 Installing UPS Software

Before Installing UPS Software

Software for configuring, monitoring and managing the HP PowerWise UPS is

located on the HP NetServer Navigator CD-ROM.

Before installing your UPS software, you must first do the following steps:

• Install your UPS using the instructions in Step 2 of the HP NetServer LH

Pro Road Map.

• Install your Network Operating System.

• (Optional) Install server management software using the instructions in the

NetServer Assistant Installation Guide.

The following sections describe the UPS installation procedures for Microsoft

Windows NT and Novell NetWare.

UPS Installation for Microsoft Windows NT

NOTE Refer to the README file located in the \pwa\winnt\disk1

directory for any updates to the installation procedure.

Before installing the software, make sure that:

• Your HP PowerWise UPS is plugged in, turned on, and connected to the

server via the serial cable. (See the instructions in the HP NetServer

LH Pro Road Map.)

• Microsoft Windows NT is up and running on your HP NetServer.

If you are using HP OpenView for Windows to manage your HP PowerWise UPS,

make sure that:

• HP OpenView for Windows is installed on your central management

console

• TCP/IP and SNMP services are installed and properly set up on

your server

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 73 74

Sem comentários

Hp Netserver L Server series Manual do Utilizador Página 25