Hp 9000 V2600 SCA Manual do Utilizador descarregar pdf (Página 75)

Chapter 3 53

SSP operation

Using the console

prompting the user if only one complex is configured). This utility

accesses the desired node based on node ID. However, the single node

must still be configured by ts_config and assigned a complex name

before it can be accessed.

Targeting commands to nodes

Use the jf-ccmd_info command to determine what names or IP

addresses the JTAG interfaces have been set to on an SPP. The command

provides a list with the following information:

• Ethernet Address (MAC)

•IP Address

• Complex Serial Number

• Node Number

• Environmental LED’s

• Power Status

• SCUB Status

• Diagnostic (JTAG) node names

The diagnostic node name or the JTAG IP address is required when

using the load_eprom command. Since the SSP software allows

changing the default JTAG hostnames and IP addresses, the user may

need to run this command to view the unique names and active IP

addresses for JTAG.

Example:

load_eprom -n COMPLEX_NAME-0000 -l /spp/firmware/diaglifhdr.fw

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 205 206

Sem comentários

Hp 9000 V2600 SCA Manual do Utilizador Página 75