Hp 9000 V2600 SCA Manual do Utilizador descarregar pdf (Página 87)

Chapter 4 65

Firmware (OBP and PDC)

HP mode boot menu

Table 10 lists the commands available from the Command: prompt.

Table 10 Boot menu commands

Command Description

AUto [BOot|SEArch|Force

ON|OFF]

Displays or sets the Autoboot or Search flag. If

Autoboot is on, the system boots automatically

after reset. If AutoSearch is on, the system

searches for and displays all I/O devices that the

system can boot from. If Autoforce is on, OBP

allows HP-UX to boot even if one or more cabinets

does not complete power on self test.

BOot [PRI|ALT|path args] Initiates the boot sequence. A default or specified

path to the boot device can be used.

BootTimer [time] Displays or sets a delay time for the system to

wait for external mass storage devices to come

online.

CLEARPIM Clears (zeros) Processor Internal Memory (PIM)

storage after a system crash. CAUTION: this

command can delete important troubleshooting

information; do not enter the CLEARPIM

command unless directed to.

CPUconfig [proc] [ON|OFF] Displays or sets the configuration of processors.

DEfault Sets the system environment variables to defined

values and changes certain HP variables so that

HP-UX can boot.

DIsplay Displays this menu.

ForthMode Switches to the Forth OBP interface. For use by

service personnel only.

IO Displays all I/O devices in the system whose SCSI

controller cards are enabled.

LS [path|flash] Displays the LIF contents (boot or flash volume)

of a device.

PASSword Defines the password used to control access to

ForthMode. Same as UNIX password command.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 205 206

Sem comentários

Hp 9000 V2600 SCA Manual do Utilizador Página 87