Hp TC4100 Manual do Utilizador descarregar pdf (Página 43)

Chapter 3 Installing and Configuring

3. Locate the DIMM slot for installation and spread the two retaining clips outward. See Figure 3-14.

Figure 3-14. Opening Retaining Clips

4. Ensure retaining clips are open and then align the notches on the DIMM with the keys on the DIMM slot,

holding the DIMM at a 90° angle to the system board. Figure 3-14.

5. Insert the DIMM fully into the slot, handling the DIMM by its edges. See Figure 3-15.

The retaining clips should grasp the DIMM automatically if it is inserted properly. If the clips do not close,

the DIMM is not inserted correctly.

Figure 3-15. Installing the DIMM

6. Re-install the Air Scoop.

CAUTION Do not rock the DIMM into place, but apply firm and even pressure. If the retaining clips

do not close, remove the DIMM and repeat Steps 5-6

emory

oar

(DIMM)

DIMM

Slot

Notch

(2 places)

Align Keys

with Notches

(2 places)

Close Retainin

Latches

(2 places)

DIMM

Open

Retainin

Latches

(2 places)

Air

Scoop

NOTE: Remove the air scoop first

by unhooking the latch on top to

release it from fan enclosure

then lift it up.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 129 130

Sem comentários

Hp TC4100 Manual do Utilizador Página 43