Hp LXR 8000 Manual do Utilizador descarregar pdf (Página 79)

f. Replace the power supply units.

– Locate the slot where the power supply unit is to be installed.

– Slide each power supply unit into its slot while squeezing the latch until it engages the connector.

– Press firmly until the power supply unit seats fully into the chassis.

Figure 18. Replacing a power supply unit

g. Replace the BBU.

– Locate the slot where the BBU is to be installed.

– Slide the BBU into the slot until it engages the backplane connector.

– Press firmly until the BBU seats fully into the chassis and the latches lock.

h. Replace the fan pack.

CAUTION The disk array must be installed so that opening the fan pack door does not interfere with any plug

on the cabinet PDU, any cables, any PDUs, or any other devices.

– Push the fan pack hinge channels onto the chassis hinge pins.

– Be sure latches seat over hinge pins.

– Close the fan pack by carefully swinging it up.

– Firmly press the fan pack against the disk array chassis until the lock/unlock button engages.

Figure 19. Replacing the fan pack

ac power

cord

Holding module at

slight angle, slide it

onto hinge pins.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 94 95

Sem comentários

Hp LXR 8000 Manual do Utilizador Página 79