HP Imaging and Printing Security Center Manual de Instalação Página 1

HP Imaging and PrintingSecurity Center Installation and Setup Guide

Verify Administrator account requirementsReview the following information before you begin the HP Imaging and Printing Security Centerinstallation.●Yo

Install the prerequisite softwareBefore installing the HP Imaging and Printing Security Center, you must have the following softwareinstalled on the c

Install Microsoft .NET Framework 3.5 SP1 on WindowsServer 2008 R2The HP Imaging and Printing Security Center requires Microsoft .NET Framework 3.5 Ser

2 Install, configure, or uninstall the HPImaging and Printing Security CenterUse the following sections to install, configure, or uninstall the HP Ima

Install the HP Imaging and Printing Security CentersystemUse the appropriate section, depending on how you are installing the HP Imaging and PrintingS

4. Review and click the I accept the terms of the license agreement button to accept the licenseagreement, and then click Next.5. For Setup Type, sele

9. If you selected Use a local database server, use the Select Database Server to select thedatabase server from the list, or click Browse to search f

computer so that it can access the HP Imaging and Printing Security Center service. The followingfigure shows the installation on computer A.Figure 2-

7. For Setup Type, select User Interface Only, and then click Next.8. For Choose Destination Location, click Next to use the default as shown, or clic

system, and then complete a full installation of the HP Imaging and Printing Security Center. Thefollowing figure shows the installation.Figure 2-3 U

6. For Setup Type, select Database Only and then click Next.7. For Select Database Server, click Browse to locate the Microsoft SQL server, select it,

14. For Choose Destination Location, click Next to use the default as shown, or click Browse toselect an alternative folder and then click Next.15. Fo

Configure remote access to the HP Imaging and PrintingSecurity Center serviceYou must configure the HP Imaging and Printing Security Center service to

Configure database security for Microsoft SQL Server2012If you use Microsoft SQL Server 2012 or SQL Server 2012 Express locally or remotely, you mustc

Configure remote database securityIf the database was installed remotely from the HP Imaging and Printing Security Center service , youmust configure

Uninstall the HP Imaging and Printing Security CentersystemUse the appropriate section to uninstall the HP Imaging and Printing Security Center system

Uninstall a remote user interface from one computerUse the following steps to uninstall the HP Imaging and Printing Security Center user interface whe

5. Indicate whether or not to remove the license file when asked Do you want to remove thelicense file?6. Log on to the computer where the HP Imaging

22 Chapter 2 Install, configure, or uninstall the HP Imaging and Printing Security Center ENWW

3 Solve problemsUse this section to solve typical installation problems.The following error is displayed when attempting to start the HP Imaging and P

HP Imaging and Printing Security CenterInstallation and Setup Guide

Attempts to start HP Imaging and Printing Security Center user interface result in error messages about the ServiceNot Running.Cause SolutionThe HP Im

A Software license agreementHEWLETT-PACKARD SOFTWARE LICENSE TERMSThe following License Terms govern your use of the accompanying Software unless you

DISCLAIMER: TO THE EXTENT ALLOWED BY LOCAL LAW, THIS SOFTWARE IS PROVIDED TOYOU "AS IS" WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, WHETHE

© 2012 Hewlett-Packard Development Company, L.P.www.hp.com

Copyright information© 2012 Copyright Hewlett-PackardDevelopment Company, L.P.Reproduction, adaptation or translationwithout prior written permission

Table of contents1 Introduction ...

iv ENWW

1IntroductionThe HP Imaging and Printing Security Center is a security compliance tool. Use it to create policies toassess the security of your imagin

System requirementsThe following lists the basic requirements for installing the HP Imaging and Printing Security Center:●Approximately 30 megabytes o

Installation overviewUsing the HP Imaging and Printing Security Center installation, you can install the service, userinterface, and database on a sin