HP D2D2502i Guia do Utilizador descarregar pdf (Página 79)

net show status

NOTE: This command applies to single-node products only.

Description of Command Function

Displays information on the network status.

Command Syntax

net show status [subnet <name>][port <name|all>][all]

Command Authority

Operator and Administrator

Command Object Requirements

Not applicable – no parameters exist within this command.

Command Parameter Requirements

• subnet – This parameter shows subnetwork status.

• port— This parameter shows port status. Use all to show status for all ports.

• all— This parameter is optional. If included in the command sequence, shows the status of all

subnets or ports, respectively.

Requirements for Command Execution

• The command entry must conform to the command syntax.

• All object values must be valid; see the object descriptions for details.

Successful Command Output

Upon successful completion of the command, information on the external network configuration is

displayed.

Command Operation during Abnormal Conditions

If the command does not conform to the required syntax, the following is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this

section.

Example

Show general network status:# net show status

Show subnetwork status: # net show status subnet subnet1

Show port status: # net show status port eth0

Show all port status: # net show status port all

Show top level status of all subnets: net show status all

net show status 79

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 177 178

Sem comentários

HP D2D2502i Guia do Utilizador Página 79