HP 4410T Manual de Serviço descarregar pdf (Página 64)

Removal and replacement procedures

Maintenance and Service Guide 4–31

✎

The thermal material must be thoroughly cleaned from the surfaces of the heat sink and the system board each time

the heat sink is removed:

■ Thermal paste is used on the processor 1 and the heat sink section 2 that services it.

■ Thermal pads are used on the Northbridge chip 3 and the heat sink section 4 that services it.

Replacement thermal material is included with all system board, heat sink, and processor spare part kits.

✎

When replacing the heat sink, be sure to remove the fan from the defective heat sink and install it on the

replacement heat sink. See “Fan” on page 4-32 for fan removal instructions.

Reverse this procedure to install the heat sink.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 124 125

Sem comentários

HP 4410T Manual de Serviço Página 64