Hp OmniBook 2000 Notebook PC Manual do Utilizador descarregar pdf (Página 27)

Troubleshooting

Solving Basic Problems

1-27

Solving Basic Problems

If your OmniBook accessory doesn’t seem to work properly, find the symptom

below that matches your situation. Try the suggestions one at a time.

This section separates problems into the following categories:

♦ Floppy disk drive problems.

♦ CD-ROM drive problems.

♦ Battery problems.

♦ Hard drive problems.

To resolve floppy disk drive problems

If a floppy drive doesn’t work

• Remove and reinsert the floppy disk.

• Check to see that the floppy disk drive configuration is correct. Note that the

floppy drive will not work on the dock parallel port—only on the OmniBook

parallel port.

1. Press FN+F2 to start the System Configuration utility.

2. From the Disks menu, click Floppy Disk Drive.

3. Select 1.44 Mb and click OK.

4. From the Exit menu, click Save and Exit.

5. Click OK.

If the OmniBook doesn’t reboot successfully from drive A

• If the OmniBook doesn’t reboot from drive A, press FN+F2 to start the System

Configuration utility. Check that the floppy drive is the first boot device.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Sem comentários

Hp OmniBook 2000 Notebook PC Manual do Utilizador Página 27