HP Waterskis E1312A Manual do Utilizador descarregar pdf (Página 163)

Multimeter Command Reference 163Chapter 3

*CLS

*CLS clears the Standard Event Status Register, the Operation Status Register, the

Questionable Signal Register, and the error queue. This clears the corresponding

summary bits (3, 5, and 7) in the Status Byte Register.

*CLS does not affect the

enable unmasks of any of the Status Registers.

Comments • Executable when Initiated: Yes

• Coupled Command: No

• Related Commands: STATus:PRESet

• *RST Condition: none

*ESE and *ESE?

*ESE <unmask> enables (unmasks) one or more event bits of the Standard Event

Status Register to be reported in bit 5 (the Standard Event Status Summary Bit) of

the Status Byte Register.

<unmask> is the sum of the decimal weights of the bits to

be enabled allowing these bits to pass through to the summary bit ESB (bit 5 in the

status byte).

*ESE? returns the current enable unmask value.

Parameters

A 1 in a bit position enables the corresponding event; a 0 disables it.

Comments • Executable when Initiated: Yes

• Coupled Command: No

• Related Commands: *ESR?, *SRE, *STB?

• *RST Condition: unaffected

• Power-On Condition: no events are enabled

Example Enable All Error Events

*ESE 60

Enable error events.

Parameter Name Parameter Type Range of Values Default Units

numeric 0 through 255 none

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 211 212

Sem comentários

HP Waterskis E1312A Manual do Utilizador Página 163