HP Z600 Especificações descarregar pdf (Página 101)

Power switch cable assembly

This section describes how to remove and install the power switch cable assembly.

Removing the power switch cable assembly

1. Disconnect power from the workstation (see Predisassembly procedures on page 73).

2. Remove the side access panel (see

Removing the side access panel on page 75).

3. Remove the right side panel (see

Removing the right side panel on page 78).

4. Remove the upper front bezel (see

Removing the upper front bezel on page 83).

5. Remove the screw from the power switch cable assembly as shown in the following figure.

Figure 5-17 Removing the power switch cable assembly

ENWW Removing and installing components 89

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 237 238

Sem comentários

HP Z600 Especificações Página 101