HP Z600 Especificações Página 103

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 102
This section describes how to remove and install a filler tray.
Removing a filler tray
1. Disconnect power from the workstation (see Predisassembly procedures on page 73).
2. Remove the side access panel (see
Removing the side access panel on page 75).
3. Lift the drive release latch at the green touch point,
and then gently slide the filler tray out of the
chassis
2
as shown in the following figure.
TIP: Excess power cables can be stored in the filler tray. Remove the cables before removing
the tray from the chassis.
Figure 5-20 Removing a filler tray
ENWW Removing and installing components 91
Vista de página 102
1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 237 238

Comentários a estes Manuais

Sem comentários