HP 10BASE-T Guia do Utilizador descarregar pdf (Página 25)

A-1

Cables and Connectors

This appendix lists cables that have been tested and verified for use with the

HP Switching Hubs. It also includes minimum pin-out information so, if you

wish to use an unlisted cable, you can verify that the cables used in your

installation are correctly wired. Note that each pin-out does not necessarily

match the pin-out for the corresponding HP cable, but cables manufactured

to follow the minimum pin-out will function correctly.

Note Incorrectly wired cabling is the most common cause of problems for LAN

communications. HP recommends that you work with a qualified LAN cable

installer for assistance with your cabling requirements.

Recommended Cables

To connect an HP Switching Hub to any Ethernet hub, use a “crossover” cable.

See that hub’s manual for crossover cable pin-outs.

You can contact your HP authorized dealer or call HP at 1-800-538-8787 to

order these parts.

Connection Cable Type HP Product Number

Switching Hub to Switching

Hub

Extender Cable 5182-9814 71cm (12.5 inch)

5182-9869 31.8 cm ((28 inch)

Hub to end node connection Twisted-pair

“straight-through”

cable

92268A, B, C, D, or N (4-pair)

92214R, S, or T (25-pair)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 43 44

Sem comentários

HP 10BASE-T Guia do Utilizador Página 25