HP 10BASE-T Guia do Utilizador descarregar pdf (Página 32)

C-2

Safety and Regulatory Statements

Power Precautions

Safety and Regulatory

Statements

Power Precautions

Follow these precautions when unplugging and plugging in power to the hub

as well as adding or removing modules.

Warning Before installing an optional module into the Expansion Slot, Management

Slot, or transceiver slot, unplug the hub. Electrical shock or other injury can

result if you attempt to install the module without unplugging the hub. If you

do not install an optional module, verify that the cover plates are covering the

slot. A cover plate is required not only for safety, but also to ensure proper

hub cooling. The rack or cabinet should be adequately secured to prevent it

from becoming unstable and/or falling over.

Caution If your installation requires a different power cord than the one supplied with

the hub, be sure to use a power cord displaying the mark of the safety agency

that defines the regulations for power cords in your country. The mark is your

assurance that the power cord can be used safely with the hub.

Note The hub does not have a power switch; it is powered on when the power cord

is plugged in. The hub’s power supply automatically adjusts to any AC power

source between 100-127 volts and 200-240 volts. There are no voltage range

settings to configure.

When installing the hub, note that the AC outlet must be installed near the

equipment and should be easily accessible.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Sem comentários

HP 10BASE-T Guia do Utilizador Página 32