HP GbE2c Manual do Utilizador descarregar pdf (Página 51)

Information Menu 51

RIP user configuration

NOTE: RIP commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.

Command: /info/l3/rip/dump <1-255>

RIP USER CONFIGURATION :

RIP on updat 30

RIP Interface 2 : 102.1.1.1, enabled

version 2, listen enabled, supply enabled, default none

poison disabled, trigg enabled, mcast enabled, metric 1

auth none,key none

RIP Interface 3 : 103.1.1.1, enabled

version 2, listen enabled, supply enabled, default none

poison disabled, trigg enabled, mcast enabled, metric 1

IP information

Command: /info/l3/ip

Interface information:

1: 47.80.23.243 255.255.254.0 47.80.23.255, up

Default gateway information:

1: 47.80.22.1, up

2: 47.80.225.2, up

Current BOOTP relay settings: OFF

0.0.0.0, 0.0.0.0

Current IP forwarding settings: OFF, dirbr disabled

Current network filter settings:

none

Current route map settings:

The following interface and default gateway information is displayed (some fields apply only to the GbE2c Layer 2/3

Ethernet Blade Switch):

• Interface number

• IP address

• IP mask

• IP broadcast address

• Operational status

• BootP relay settings

• IP forwarding settings

• Network filter settings

• Route map settings

IGMP multicast group information

Command: /info/l3/igmp

[IGMP Multicast Group Menu]

mrouter - Show IGMP Snooping Multicast Router Port information

find - Show a single group by IP group address

vlan - Show groups on a single vlan

port - Show groups on a single port

trunk - Show groups on a single trunk

dump - Show all groups

The following table describes the commands used to display information about IGMP groups learned by the switch.

Table 35 IGMP Multicast Group menu options

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 174 175

Comentários a estes Manuais

Sem comentários

HP GbE2c Manual do Utilizador Página 51

Comentários a estes Manuais

Manuais e produtos relacionados com Comutadores de rede HP GbE2c