HP HyperFabric Manual de Instalação descarregar pdf (Página 110)

Managing HyperFabric

Starting HyperFabric

Chapter 4

The clic_start -? command can be issued to display the online help for clic_start,

or look at the clic_start (1m) man page by issuing the man clic_start command.

If HyperFabric is already running, you will receive an informational (FYI) message

telling you so. Your reaction to this message depends on the situation:

• If you have simply forgotten (or did not know) that HyperFabric was already

running, you do not have to do anything.

• If you have changed the HyperFabric configuration with the clic_init command or

SAM, you must stop HyperFabric (by running the clic_shutdown command or using

SAM) and then start HyperFabric (by running the clic_start command or using

SAM). See either “Using the clic_shutdown Command” on page 99 or “Using

SAM—HP-UX 11.0 and 11i 0nly” on page 100, whichever is appropriate.

Using SAM—HP-UX 11.0 and 11i 0nly

To use SAM to start HyperFabric on an HP 9000 system running HP-UX 11.0 or 11i,

follow these steps:

Step 1. Start SAM.

Step 2. Select the “Networking and Communications” area.

Step 3. Select “HyperFabric.”

Step 4. Pull down the “Actions” menu and select Start HyperFabric. Note that with a HP-UX

11.0 operating system, if HyperFabric is already running, Start HyperFabric is grayed

out and cannot be selected. With a HP-UX 11i operating system, if HyperFabric is

already running, Start HyperFabric is not grayed out. With HP-UX 11i the newly

added adapter can be configured and started (using OLA), without doing a

clic_shutdown or a clic_start on the node.

When HyperFabric starts, a confirmation message displays. Also, the status

“HyperFabric: Running” is displayed above the adapter configuration area of the screen.

Step 5. Exit SAM.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 155 156

Sem comentários

HP HyperFabric Manual de Instalação Página 110