HP HyperFabric Manual de Instalação Página 136

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 135
Troubleshooting HyperFabric
LED Colors and Their Meanings
Chapter 5
112
The adapter is connected to a non-operational adapter in the remote node (in a
node-to-node configuration).
If the connection from the adapter to the corresponding switch port (if a switch is
used) or the corresponding adapter in the remote node (in a node-to-node
configuration) is operational, the Connected/Traffic, Link, or Link
Connected/Traffic LED on the adapter shows as solid green.
If data is flowing between the adapter and the switch port (if a switch is used) or the
corresponding adapter in the remote node (in a node-to-node configuration), the
Connected/Traffic, Link, or Link Connected/Traffic LED shows as flashing
green. Note that data does not start to flow until HyperFabric initialization has
occurred (see Using the clic_init Command on page 92).
If the adapter is in an error state that requires it to be replaced, the Error LED on
the adapter shows as solid yellow. See Replacing a HyperFabric Adapter on
page 125 if you need to replace an adapter.
Table 5-2 below summarizes the adapter LED information in a table format.
Vista de página 135
1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 155 156

Comentários a estes Manuais

Sem comentários