HP 100VG Guia do Utilizador descarregar pdf (Página 10)

1-2

Installation

Installing the Module

Installation

1. Unscrew the two captured screws holding the cover plate to the hub’s

100VG Expansion Slot and remove the cover. Note that the screws will

release outward when unscrewed far enough. Do not unscrew them

completely from the cover plate. Also notice that only modules with a

“Compatible Modules Only” sticker on the component board are to be

inserted into the hub.

2. (Optional step). If you want to bridge your 100VG network to a 10Base-

T network, install an optional 10Base-T transceiver into the AUI/Xcvr Slot

on the module. See the module insertion and cable connection instruc-

tions in the installation guide that came with the transceiver manual.

Note If you install this module into the HP J2410A AdvanceStack Hub-15, the AUI/

Xcvr Slot located on the front of the hub is no longer available. A cable

connected to that port will not transfer data. That 10Base-T transceiver slot

on the front of that hub is only used with the HP J2414A SNMP/Bridge Module.

3. Insert the HP 100VG SNMP/Bridge Module into the hub’s expansion slot.

Leading with the hub connector edge, line up the sides of the module with

the rails on the sides of the hub’s Expansion Slot. Then push the module

into the slot until it is firmly seated in the connector in the back of the slot.

4. Tighten the two screws that hold it in place. Be careful not to overtighten

the screws.

Hub expansion slot

“Compatible Modules Only” sticker

loosen these two screws

Hub

connector

Module shown has

optional twisted-pair

transceiver installed

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 45 46

Sem comentários

HP 100VG Guia do Utilizador Página 10