HP E5000 Guia do Utilizador descarregar pdf (Página 109)

8. Lift the release tab on the side or bottom rail (1, Figure 114 (page 109)), and then slide the

rail toward the front of the drive drawer to remove the rail (2).

NOTE: Repeat this step for all rails.

Figure 114 Removing the drive drawer rails

Replacing the drive drawer rails

1. Align the replacement rail with the tabs, and slide it toward the back of the drive drawer until

the rail locks into place (Figure 115 (page 109)).

Figure 115 Installing the drive drawer rails

2. Align the replacement drive drawer rail with the three enclosure rails and then push the drive

drawer partially back into the system enclosure so that approximately two inches of the drawer

is still out of the enclosure (Figure 116 (page 110)).

CAUTION: Do not push the drive drawer completely into the enclosure. You must first connect

the power coil assembly to prevent damaging the power coil assembly.

Removing and replacing the drive drawer rails (side or bottom) 109

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 198 199

Sem comentários

HP E5000 Guia do Utilizador Página 109