HP C100/110 Manual de Serviço descarregar pdf (Página 162)

146

Changing Your Workstation’s Hardware Conﬁguration

Installing Additional memory

3 Close the ejector tabs on each side of the memory connector. See Figure 38.

Figure 38 Installing Memory Cards

4 Place the memory module in the connector, lining it up with the guides. Make

sure to put the notched end toward the left, as shown in Figure 38.

5 Press firmly and evenly on the memory module to ensure that it seats properly.

6 Replace the main tray assembly as described in “Replacing the Main Tray As-

sembly” earlier in this appendix.

To verify that this installation was successful, follow the steps in Appendix

D, “The Boot Console Interface,” on displaying memory information. If you

have only replaced a faulty memory module, you must issue the pdt clear

command in the service menu of the Boot Console Interface. Answer yes (y)

to the prompt “Continue? (Y/N) >.”

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 251 252

Sem comentários

HP C100/110 Manual de Serviço Página 162