HP C100/110 Manual de Serviço descarregar pdf (Página 170)

154

Changing Your Workstation’s Hardware Conﬁguration

Replacing the Battery

1 Remove the main tray as described in Removing the Main Tray Assembly

earlier in this chapter.

2 Note the orientation of the battery. Make sure that you put the new battery in

place with the positive (+) side facing in the same direction.

3 Lift the clip and slip the battery out of its holder, as shown in Figure 42.

Figure 46 Removing the Battery

4 Insert the new battery in the same orientation as the old one. (Only use HP part

number 1420-0314 or equivalent.)

NOTICE: If you cannot gain access to the battery, you may need to remove an option

board. Refer to Installing an EISA or GSC Option Board earlier in this

chapter for information on accessing the option boards.

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with

the same or equivalent type recommended by the manufacturer.

ATTENTION: Il y a danger d’explosion s’il y a remplacement incorrect de la batterie.

Remplacer uniquement avec une batterie du même type ou d’un type

recommandé par le constructeur. Mettre au rébut les batteries usagées

conformément aux instructions du fabricant.

5 Follow the instructions in Replacing the Main Tray Assembly earlier in this chap-

ter to close and restart the system.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 251 252

Sem comentários

HP C100/110 Manual de Serviço Página 170