HP Converged Network Adapters (CNA) Manual de Instalação descarregar pdf (Página 4)

1 Introduction

Overview

The HP Integrity NC552SFP 2P 10GbE adapter is a dual port 10GbE adapter for the HP Integrity

rx2800 i2 and Superdome2 systems. The HP Product number is AT118A. These two descriptions

refer to the same device and are used interchangeably throughout this document.

The AT118A adapter uses the BladeEngines 3 (BE3) Emulex chip and is an eight lane (x8) PCI

Express (PCIe) 10 Gigabit network controller offering optimal throughput. This PCI Express Gen 2

adapter ships with two SFP+ (Small Form-factor Pluggable) cages suitable for connecting to Direct

Attach Cable (DAC) or fiber optic modules supporting SR fiber optic cabling. The adapter ships

with a standard height bracket installed by default. A low profile bracket is also available for use

in a low profile PCIe slot.

For more information about the AT118A adapter, see the following HP website:

http://www.hp.com/go/hpux-11iv3-iocards-manuals

LED indicators

The AT118A adapter has two ports with LED indicators for Link (L) and Activity (A) for each

port. Standard-height bracket is shown below with the SFP+ ports and LED indicators.

Figure 1 The AT118A adapter

The operation of the AT118A adapter LED indicators are explained in the following table: Table 1

Table 1 AT118A LED Indicators

DescriptionStatusLED Indicator

Indicates no network activity on the link.OffActivity (A)

Indicates network activity on the link. The adapter is sending or receiving network data

at up to 10 Gbps.

Flashing

(Green)

No link to the adapter is established. The adapter is not receiving power or the cable

connection is faulty.

OffLink (L)

Link to the adapter is established. The adapter is receiving power and the cable

connection is good.

On (Yellow)

4 Introduction

1 2 3 4 5 6 7 8 9 ... 19 20

Sem comentários

HP Converged Network Adapters (CNA) Manual de Instalação Página 4