HP Converged Network Adapters (CNA) Manual de Instalação descarregar pdf (Página 6)

2 Installing an adapter

IMPORTANT: See the following chapter before installing the AT118A adapter: “Installing the

HP-UX operating system components” (page 8)

Preventing electrostatic discharge

To prevent damaging the system, be aware of the precautions you need to follow when setting up

the system or handling parts. A discharge of static electricity from a finger or other conductor may

damage system boards or other static-sensitive devices. This type of damage may reduce the life

expectancy of the device.

To prevent electrostatic damage:

• Avoid hand contact by transporting and storing products in static-safe containers.

• Keep electrostatic-sensitive parts in their containers until they arrive at static-free workstations.

• Place parts on a grounded surface before removing them from their containers.

• Avoid touching pins, leads, or circuitry.

• Always be properly grounded when touching a static-sensitive component or assembly.

Installing an adapter in a server

See the HP Integrity rx2800 i2 and Superdome server documentation for additional information

on how to safely install a PCI Express card in the server.

NOTE: A minimum of two Gigabytes (2 GB) of server memory is required per each adapter.

NOTE: Direct Attach Cable (DAC) for copper environments or fiber transceivers and cables for

fiber-optic environments must be purchased separately.

The Online Addition and Replacement feature, OL* for the HP-UX 11i v3 release, enables PCI host

bus adapters to be added or replaced without shutting down and rebooting the system, and without

adversely affecting other system components. The system hardware uses slot-specific power control,

combined with HP-UX operating system support, to enable these features.

Confirm whether OL* is supported on the system in which you plan to install an Ethernet adapter.

See the HP Ethernet System-Driver Support Matrix, at the following website:

http://www.hp.com/go/hpux-11iv3-iocards-manuals

IMPORTANT: Superdome systems are not intended to be maintained by customers. HP recommends

that Superdome systems only be opened by a qualified HP service engineer. Failure to observe

this recommendation can invalidate any support agreement or warranty to which you may be

entitled.

NOTE: The optical port protector is used only to protect the adapter port when it is not in use.

Do not use the protector as a diagnostic tool.

Install all driver software and dependent patches before you install the adapter. For more

information, see “Prerequisites” (page 8)

1. Install all driver software and dependent patches.

2. Shut down the system.

3. If a low profile option slot is to be used, install the low profile bracket onto the adapter.

NOTE: See the following procedure “Installing a low profile bracket” (page 7).

6 Installing an adapter

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Sem comentários

HP Converged Network Adapters (CNA) Manual de Instalação Página 6