HP NetServer LXr 8500 Guia do Utilizador descarregar pdf (Página 10)

Chapter 1 Server Administration Using HP TopTools

NOTE The Power button is the only button required to do basic Hot

Plug Replacement operations.

Figure 5. Pop-up Menu

4. Confirm your selection by clicking on Yes.

As soon as confirmation is complete, the left P (Power) LED in the Utility

window turns off (gray) and the slot status changes from "Link Fault" (or

Normal) to Not Ready. The corresponding Power LED (green) for the PCI

slot on the rear panel will also turn off. This means power to this slot is

turned off. See Figure 6.

CAUTION If the rear panel Power LED for the desired PCI slot does not

turn off, do not attempt to remove the PCI Hot Plug board.

Return to Step 1 in this procedure to ensure you have selected

the correct slot to power down.

NOTE If you have a PCI board with a non-compliant drive in the

desired PCI slot, the PCI board will show up on the Utility’s

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 46 47

Sem comentários

HP NetServer LXr 8500 Guia do Utilizador Página 10