HP NetServer LXr 8500 Guia do Utilizador descarregar pdf (Página 19)

Chapter 1 PCI Hot Plug Utility for Microsoft Windows NT

5. As the left P LED turns green, observe the right A LED and the board

status while you wait a few seconds for the software driver to initialize the

PCI board. See Figure 13.

The left P (Power) LED should be green at this point.

Figure 13. PCI Hot Plug Utility –Power Turned On

6. If the right A (Attention) LED stays red in the Hot Plug Utility window

and the rear panel Attention LED stays Amber, then consider these steps:

a. Ensure all the required cables are attached to the adapter.

b. Power down the slot as described in Steps 2 to 5 of the section

"Powering Down the PCI Slot" and then re-seat the PCI board.

c. Ensure an identical PCI board was used as a replacement.

d. Write down the part number and revision level of the PCI board and

then contact the manufacturer to determine if a new software driver is

required.

If necessary, install a new driver and repeat this procedure. See the

Help file for more information.

7. Observe the two LEDs for this slot on the rear panel.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 46 47

Sem comentários

HP NetServer LXr 8500 Guia do Utilizador Página 19