
HP ProDesk 490 G1 Microtower Business PC
Technical Specifications – Power
c04123126 —14695 — Worldwide — Version 9 —January 21, 2015
Unit Environment and Operating Conditions
General Unit Operating Guidelines
Keep the computer away from excessive moisture, direct moisture and the extremes of heat and cold, to ensure that unit
is operated within the specified operating range.
Leave a 10.2 cm (4 in) clearance on all vented sides of the computer to permit the required airflow.
Never restrict airflow into the computer by blocking any vents or air intakes.
Do not stack computers on top of each other or place computers so near each other that they are subject to each other's
re-circulated or preheated air.
Occasionally clean the air vents on the front, back, and any other vented side of the computer. Lint, dust and other
foreign matter can block the vents and limit the airflow.
If the computer is to be operated within a separate enclosure, intake and exhaust ventilation must be provided on the
enclosure, and the same operating guidelines listed above will still apply.
Operating: 50° to 95° F (10° to 35° C)*
Non-operating: –22° to 140° F(–30° to 60° C)
Operating: 10% to 90% (non-condensing at ambient)
Non-operating: 5% to 95% (non-condensing at ambient)
Maximum
Altitude (unpressurized)
Operating: 10,000 ft (3048 m)
Non-operating: 30,000 ft (9144 m)
*Operating temperature is de-rated 1.0 deg C per 300 m (1000 ft) to 3000 m (10,000 ft) above sea level, no direct sustained
sunlight. Maximum rate of change is 10 deg C/Hr. The upper limit may be limited by the type and number of options installed.
300W active PFC
(230 VAC input only)
82/85/82% efficient at 20/50/100% load (115V)
82/85/82% efficient at 20/50/100% load (230V)
200 - 240 VAC (300W active PFC)
Rated Input Current with Energy Efficient* Power Supply
Less than 500 microamps of leakage current at
120 Vac with the ground wire disconnected, as
required for Non-patient Electrical Appliances
and Equipment used in a patient care facility or
that contact patients in normal use. Per section
10.3.5.1.
Less than 100 microamps of leakage current at
120 Vac with the ground wire intact with normal
polarity, as required for Non-patient Electrical
Comentários a estes Manuais