
HP rp2400 Series of Servers - Basic Cable Connections
Console Connection and Configuration
Chapter 1
12
rp24xx Server RS-232 System Local Console Installation
The following describes how to install a system console on an rp24xx Server. The HP-700 series terminal is
used as an example. Other terminals may be used as a system console as long as they are configured for
VT100 terminal emulation mode.
1. Connect the 25-pin end of the A5191-63001 adapter cable to the 25-pin connector on the Console/UPS Port
located on the rear.
2. Connect the 9-pin, “Console,” connector of a A5191-63001 adapter to the 9-pin D-type connector on a
24542G RS-232 cable.
Figure 1-5 Console/Remote-Modem/UPS Connector
3. Connect the 25-pin end of the 24542G serial cable to the serial/RS232 port on the Console. (RS232 Serial
Port labeling may vary depending on manufacturer.)
4. Connect the System Console to input AC power.
5. Turn the System Console AC power switch to ON.
Console Configuration (VT100 mode)
The following describes the steps required to configure system consoles for VT-100 mode for operation with
the rp24xx server.
C1099A VT-100 Mode Configuration.
The following procedure outlines the steps to configure the C1099A terminal for VT-100 operation.
To access the Setup menu in HPTerm emulation:
1. Press the
F10 key to display the terminal local function labels, then Press F8 (config keys).
You are now in the Quick (
F1) menu.
2. Select the VT100 emulation by using the space bar to navigate through the available options.
3. Press the
ESC key to save selected setup parameters and to exit the Setup menu.
4. Press the
Y key when the blinking prompt
Save all? (Y/N)
appears in the upper right corner of the menu to save the settings in non-volatile memory.
100-240V~, 600W
6.0-2.6A, 50-60Hz
Ultra 2 Wide SCSI
Path: 0/0/1/ 0
Narro w S ingle Ended SCSI
Path: 0/0/2/ 0
A
B
GSP Reset TO C
10/100BASE- T
Path: 0/0/0/ 0
10BASE- T
LAN Consol e
Console/
UPS Por t
Path: 0/2/0 Path: 0/4/0
Path: 0/6/ 2
Path: 0/6/ 0
wi n
urbo
wi n
urbo
ccrr012
Console/Remote-Modem/UPS Connector
(D-Type 25-Pin female)
Requires: A5191-63001 “W” adapter cable
Comentários a estes Manuais