HP Visualize c3000 - Workstation Manual de Instruções descarregar pdf (Página 123)

Chapter 4 123

Field Replaceable Units

FRU Removal and Replacement

Figure 4-49. Master and Slave Voltage Regulator Modules

Perform the following steps to replace a voltage regulator module:

1. Press down on the ejector tabs on either side of the system board connector to open

them. Be sure that you will be inserting the voltage regulator module into the correct

system board connector (the top connector if it is a master voltage regulator module, or

the bottom connector nearest the chassis floor if it is a slave).

2. Orient the notch on the gold edge of the voltage regulator module so that it aligns with

the notch-key in the system board connector. Push the voltage regulator module into the

correct system board connector (the top connector if it is a master voltage regulator

module, or the bottom connector nearest the chassis floor if it is a slave) until the

voltage regulator module is seated entirely in the connector.

NOTE

The ejector tabs will return to the locked position when the voltage regulator

module is fully seated in the connector.

3. Slide the power supply towards the rear of the workstation. You must engage the hook

on the bottom of the power supply into the support strap in the chassis floor.

4. Screw in the four T-15 Torx screws that hold the power supply in place into the rear of

the chassis. See Figure 4-47.

5. Close the left side panel of the workstation as shown in the section “Closing the Left

Side Panel.”

Notch

Master

Slave

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 203 204

Sem comentários

HP Visualize c3000 - Workstation Manual de Instruções Página 123