HP Visualize c3000 - Workstation Manual de Instruções descarregar pdf (Página 90)

90 Chapter 4

Field Replaceable Units

FRU Removal and Replacement

Power Switch/LCD Assembly

This section explains how to remove and replace the power switch/LCD assembly, which is

located on the front panel of the B2000 workstation.

Removing the Power Switch/LCD Assembly

Perform the following steps to remove the power switch/LCD assembly:

1. Open the workstation’s front panel as shown in the section “Opening the Front Panel.”

2. Unplug the power switch/LCD assembly’s connector as shown in Figure 4-4.

Figure 4-4. Removing the Power Switch/LCD Assembly

3. Press inward on the mounting clip located on the right side of the power switch/LCD

assembly and pull the right side of the assembly outward in a clockwise motion. See

Figure 4-4. This action releases the mounting clips on the left side of the power

switch/LCD assembly.

Replacing the Power Switch/LCD Assembly

Perform the following steps to replace the power switch/LCD assembly:

1. Open the workstation’s front panel as shown in the section “Opening the Front Panel.”

2. Insert the mounting clips on the left side of the power switch/LCD assembly into the

slots on the workstation chassis. See Figure 4-4.

3. Press inward on the mount clip located on the right side of the power switch/LCD

assembly and insert this clip into the hole provided for it on the workstation chassis.

4. Plug in the power switch/LCD assembly’s connector.

5. Close the workstation’s front panel as shown in the section “Closing the Front Panel.”

Assembly Connector

Power Switch/LCD

Right Side

Left Side

Power Switch/LCD

Assembly

Mounting Clip

Mounting Clips

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 203 204

Sem comentários

HP Visualize c3000 - Workstation Manual de Instruções Página 90