HP Workstation x4000 Guia de Instalação descarregar pdf (Página 14)

8. Remove the two heatsink clips by pressing the release lever on the

clips. Then lift off the heatsink. There is a thermal interface material

between the heatsink and the processor. This may cause the processor

to stick to the heatsink.

Figure 1-3 Removing a Processor

9. Remove the thermal interface material from the heatsink and discard

it. You can leave any residue that remains on the heatsink. This does

not impair the heat transfer.

10.Open the Zero Insertion Force (ZIF) lever, located at the side of the

processor socket, until it is in the vertical position (depending on the

socket design, the handle may need to go past vertical), then carefully

lift out the processor. To avoid bending the processor pins, keep the

processor perfectly flat when removing it.

11.Store the processor in an anti-static bag (such as the one provided

with the replacement processor).

12.If you are permanently removing a second processor,you must update

your operating system (see page 16). You should also store the

heatsink and clips in a safe place.

Installing a Processor

To install a processor:

1. Turn off the display and shut down the Workstation. Disconnect all

power cables and any LAN or telecommunications cables.

2. Remove the Workstation’s cover.

3. Place the Workstation on its side for better access.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Sem comentários

HP Workstation x4000 Guia de Instalação Página 14