HP xw6000 Guia do Utilizador descarregar pdf (Página 55)

Hardware Reference Guide 2–27

Hardware Upgrades

5. Install the second processor (refer to the illustration on the

following page):

a. Open the secondary processor socket lever

fully (the full

swing angle of the lever is approximately 135 degrees).

CAUTION:

Processor pins are delicate and bend easily. Use extreme

care when placing the processor in the socket.

b. Line up the two keyed corners of the pins on the processor

with the two keyed corners of the processor socket and install

the processor into the socket. Ensure that the underside of the

processor is level with the top of the processor socket.

CAUTION:

If only one processor is installed, and you are replacing that

processor, be sure to install the processor in the primary processor socket

or your workstation will not function.

c. Lightly press down on the top of the processor while closing

the socket lever.

d. Check for proper processor seating in the socket. Using

your fingers, carefully try to lift the processor out of the

socket. A properly seated processor will not lift out of

the socket.

Longbow.book Page 27 Thursday, August 22, 2002 11:38 AM

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 82 83

Sem comentários

HP xw6000 Guia do Utilizador Página 55