HP 1055CM Manual do Utilizador descarregar pdf (Página 26)

Troubleshooting

1-14

HP DesignJets 1050C and 1055CM Printers Service Manual

Solving Media-Handling Problems

The Front Panel Keeps Indicating that Media Is Misaligned or

Incorrectly Positioned

Roll media The roll may be loaded the wrong way. The paper should load

over the roll toward you.

The paper may be loaded at an angle. The right-hand edge must

be parallel to the white line on the paper entry roller.

WARNING Ensure that the paper is wrapped tightly on the roll. This is a

very important step to remember because if this is not done, the

media may be loaded at an angle, causing the media to be

rejected.

Perform the manual alignment procedure (Refer to the User’s

Guide).

Check that the paper is correctly loaded onto the spindle.

Sheet media It must be loaded with the right-hand edge against the blue

perforated line on the printer.

The media may be crumpled or warped or may have irregular

edges.

If you are using hand-cut media, the edges may not form a right-

angle or they may be rough. Do not use hand-cut media. Use only

purchased sheet media.

If the media you are trying to load is very slippery, hold the

media with both hands, and gently push the media into the printer

until it buckles upwards in the middle, this will help the printer to

load it.

If the overdrive is covered in dust, it will have problems picking

up the sheet media during the load process. Clean the Overdrive

using the Overdrive Cleaning Service Utility ⇒ Page 4-37.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 321 322

Sem comentários

HP 1055CM Manual do Utilizador Página 26