HP 61-in Manual do Utilizador descarregar pdf (Página 60)

NOTE: If you know that the automatic search for the reference line is not working (perhaps

because the substrate-advance sensor is dirty), you can turn it off: select the

icon, then select

Substrate handling options > Auto line detection > Off.

10. Send one or more jobs to be printed on the second side. If you send more than one job, they

should be sent in reverse order, because printing starts at the end of the second side and works

back towards the beginning.

NOTE: The jobs printed on the second side should probably be rotated 180 degrees, and may

need to be slightly reduced in size to compensate for the contraction of the substrate after passing

once through the printer. See also the Maintenance and troubleshooting guide.

View information about the substrate

On the printer's front panel, select the icon, then select View loaded substrate > View

substrate details.

The following information appears on the front panel:

●

The roll status

●

The substrate family that you have selected

●

The width of the substrate in millimeters (estimated by the printer)

If no substrate is loaded, the message Out of substrate appears.

The same information appears on the Embedded Web Server's Supplies page.

56 Chapter 4 Handle the substrate ENWW

Handle the substrate

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 94 95

Sem comentários

HP 61-in Manual do Utilizador Página 60