
E–12 Service Reference Guide
Diagnostic Error Codes
XXXX-35 Invalid SCSI bus phase. Replace the indicated device.
XXXX-36 Invalid SCSI bus phase. Replace the indicated device.
XXXX-39 Error status from drive. Replace the indicated device.
XXXX-40 Target timed out. Replace the indicated device.
XXXX-41 SCSI bus stayed busy. Replace the indicated device.
XXXX-42 ACK/REQ lines bad. Replace the indicated device.
XXXX-43 ACK did not deassert. Replace the indicated device.
XXXX-44 Parity error. Replace the indicated device.
XXXX-50 Data pins bad. Replace the indicated device.
XXXX-51 Data line 7 bad. Replace the indicated device.
XXXX-52 MSG, C/D, and/or I/O lines
bad.
Replace the indicated device.
XXXX-53 BSY never went busy. Replace the indicated device.
XXXX-54 BSY stayed busy. Replace the indicated device.
XXXX-60 Controller CONFIG-1 register
bad
Replace the indicated device.
XXXX-61 Controller CONFIG-2 register
bad
Replace the indicated device.
XXXX-65 Media not unloaded. Replace the indicated device.
XXXX-90 Fain failure. 1. Ensure fan(s) connected.
2. Replace nonfunctional fan(s).
XXXX-91 Over temperature. 1. Ensure proper air flow.
2. Perform required maintenance and
cleaning.
XXXX-99 Autoloader reported tapes not
loaded properly.
1. Install tape(s) in autoloader tape drive
according to test instructions.
2. Change autoloader magazine.
Test Error Codes (Continued)
Error Code Description Recommended Action
Comentários a estes Manuais