HP Z Virtual Workstation series Manual do Utilizador descarregar pdf (Página 61)

. Connect the power and data cable to the system board and the optical drive.

Install the access panel on page 20.

. Install the server into the rack (

Installing the server into the rack on page 35).

10. Connect each power cord to the server.

. Connect each power cord to the power source.

Power up the server on page 18.

48V DC power supply option

One of the following optional HP input cables with pre-fastened ring tongues may be purchased from

HP or an authorized reseller:

●

A5S97A—1.3-m (4.27-ft) 48V DC Power Cable Kit

●

A5S98A—2.5-m (8.20-ft) 48V DC Power Cable Kit

If you are not using an optional HP input cable, use an HP-approved 10 or 12 AWG green and yellow

ground cable, no shorter than 150 cm (59.06 in), and 10 or 12 AWG power cables.

To install the component:

. Remove the blank.

48V DC power supply option 55

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 110 111

Sem comentários

HP Z Virtual Workstation series Manual do Utilizador Página 61