HP Z200 Especificações descarregar pdf (Página 113)

5. Push down on the expansion card retention clamp levers on the inside of the chassis to open the

retention clamp (1) as shown below.

Figure 5-31 Removing the expansion card

6. If the card is in one of the slots with a latch, release the latch (2). (Note that there are two different

styles of latch.)

7. Carefully lift the card from the chassis (3).

8. If you are not replacing the card in this slot, install an expansion slot cover and close the expansion

card retention clamp.

If the expansion card retention clamp does not close, ensure that all cards are properly seated,

and then try again.

ENWW Removing and installing components 101

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 191 192

Sem comentários

HP Z200 Especificações Página 113