HP 3PAR Guia do Utilizador descarregar pdf (Página 337)

100

101

Specifies the ID of the system to be started.

<toc_gen_number>

Specifies the table of contents generation number for the system to start with.

<disk_quorum>

Specifies the disk quorum for the system to start with.

RESTRICTIONS

• Access to all domains is required to run this command.

• Use this command only when the system cannot start up normally.

EXAMPLES

The following example starts system mysystem in the new system state:

cli% setsysmgr wipe mysystem systemid

The following example starts the system with the table of contents generation number of 42956,

where 91 is the highest disk quorum displayed:

cli% setsysmgr tocgen 42956 91

The following example displays the start of a system’s recovery process from its IDE disk:

cli% setsysmgr force_iderecovery

NOTES

• If the wipe subcommand is specified, all system data and configuration information, including

customer data and VV layout, are destroyed.

• If the force_iderecovery subcommand is specified, the system can delete data for some

of the unstarted VVs. The system can run the checkvv and checkld commands to make the

VVs and logical disks consistent, thereby resulting in a possible data loss.

setsysmgr 337

1 2 ... 332 333 334 335 336 337 338 339 340 341 342 ... 675 676

Comentários a estes Manuais

Sem comentários

HP 3PAR Guia do Utilizador Página 337

Comentários a estes Manuais

Manuais e produtos relacionados com Software HP 3PAR