HP 4000S Guia do Utilizador descarregar pdf (Página 42)

Basic Administrative Procedures and Setup Completion

42 NAS 4000s and 9000s Administration Guide

Figure 17: NIC Properties, Teaming Controls tab, Fault Tolerant option

4. Configure the team by choosing either Fault Tolerant or Load Balancing.

The fault tolerance and load balancing options are discussed in the following sections.

Fault Tolerance

The Fault Tolerance teaming option provides three redundancy control options:

■ Manual—This setting allows change from a Primary NIC to a Secondary NIC only when

Switch Now is clicked.

Note: The Switch Now option is disabled until Manual is selected and then OK is clicked.

■ Fail on Fault—This setting automatically switches from a primary NIC to a secondary

NIC when the primary NIC fails.

■ Smart Switch—This setting lets a member of a team be selected as the preferred Primary

Smart Switch NIC. As long as this NIC is operational, it is always the active NIC. If the

NIC fails and it is eventually restored or replaced, it automatically resumes its status as the

active NIC.

Note: Smart Switch is the recommended choice for fault tolerance.

Detailed information about configuring teams for fault tolerance can be found in the HP

Network Teaming utility help.

Load Balancing

The Load Balancing teaming option provides four load balancing control options:

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 245 246

Sem comentários

HP 4000S Guia do Utilizador Página 42