HP B.06.X Manual do Utilizador descarregar pdf (Página 33)

Installing and Configuring PPU Software

Re-installing PPU Software

Chapter 3 33

Re-installing PPU Software

If you re-install HP-UX on a PPU system (for example, installing HP-UX

by either cold-installing or installing from a “golden image”), you need to

perform the following steps to restore your PPU configuration:

Step 1. Manually save your PPU configuration file by backing up the following

file: /etc/ppu/ppu_config

Step 2. Install the PPU software (see “Installing PPU Software” on page 26 for

details)

Step 3. Restore your PPU configuration file (from

Step 1): /etc/ppu/ppu_config

Step 4. Start the ppud daemon (see “Manually Starting the ppud Daemon” on

page 32 for details)

NOTE An alternative method is to: install the PPU software and configure the

utility meter, thus starting the ppud daemon.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 77 78

Sem comentários

HP B.06.X Manual do Utilizador Página 33