Hp Insight Management Agents Manual do Utilizador descarregar pdf (Página 104)

◦ noDigest

◦ crc32c

Sub-system Classification

Power Subsystem

This section displays information about the redundant power supplies. The following entries may

be displayed:

• Location—Displays the bay where the power supply is located.

• Condition—Displays the status of the power supply. The following values are possible:

OK—A power supply is installed and operating normally.◦

◦ Failed—A power supply is installed and is no longer operating. Replace the power supply.

◦ Not Installed—Nothing is installed in this power supply bay.

◦ Unknown—The Server Agent is unable to determine if this storage system power supply

bay is occupied.

• Serial Number—Displays the serial number of the power supply. This information can be used

for identification purposes.

• Firmware Revision—Displays the firmware revision of the power supply.

• Present—Represents whether the power supply is present in the chassis.

• Status—Represents the status of the power supply in the chassis. The following values are

possible:

◦ No Error

◦ General Failure

◦ Bist Failure

◦ Fan Failure

◦ Temperature Failure

◦ Interlock Open

◦ EPROM Failed

◦ VREF Failed

◦ DAC Failed

◦ RAM Test Failed

◦ Voltage Channel Failed

◦ Orring Diode Failed

◦ Brownout

◦ Give Up On Startup

◦ NVRAM Invalid

◦ Calibration Table Invalid

◦ If the power supply is absent, the status is "Not Applicable"

• Used Capacity (%)—Represents the current power supply capacity which is a percentage of

its maximum capacity.

• Used Capacity (W)—Represents the current power supply capacity in watts.

104 Agent information

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 160 161

Sem comentários

Hp Insight Management Agents Manual do Utilizador Página 104