HP Moonshot-180G Guia do Utilizador descarregar pdf (Página 202)

100

101

Simple Network Time Protocol Commands

CLI Command Reference

September 2014 Page 202

HP Moonshot Switch Module CLI Command Reference

sntp server

This command configures an SNTP server (a maximum of three). The server address can be either an IPv4

address or an IPv6 address. The optional priority can be a value of 1-3, the version a value of 1-4, and the port

id a value of 1-65535.

no sntp server

This command deletes an server from the configured SNTP servers.

sntp source-interface

Use this command to specify the physical or logical interface to use as the source interface (source IP address)

for SNTP unicast server configuration. If configured, the address of source Interface is used for all SNTP

communications between the SNTP server and the SNTP client. The selected source-interface IP address is

used for filling the IP header of management protocol packets. This allows security devices (firewalls) to

identify the source packets coming from the specific switch. If a source-interface is not specified, the primary

IP address of the originating (outbound) interface is used as the source address. If the configured interface is

down, the SNTP client falls back to its default behavior.

no sntp source-interface

Use this command to reset the SNTP source interface to the default settings.

Format

sntp server {ipaddress | ipv6address | hostname} [priority [version [portid]]]

Mode Global Config

Format

no sntp server remove {ipaddress | ipv6address | hostname}

Mode Global Config

Format

sntp source-interface {unit/slot/port | loopback loopback-id | vlan vlan-id}

Mode Global Config

Parameter Description

unit/slot/port The unit identifier assigned to the switch.

loopback-id Configures the loopback interface. The range of the loopback ID is 0 to 7.

tunnel-id Configures the IPv6 tunnel interface. The range of the tunnel ID is 0 to 7.

vlan-id Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is

1 to 4093.

Format

no sntp source-interface

Mode Global Config

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 718 719

Comentários a estes Manuais

Sem comentários

HP Moonshot-180G Guia do Utilizador Página 202

Comentários a estes Manuais

Manuais e produtos relacionados com Software HP Moonshot-180G