HP PROCURVE 6120 Manual do Utilizador descarregar pdf (Página 339)

100

101

13-47

Configuring for Network Management Applications

LLDP (Link-Layer Discovery Protocol)

■ Add entries to its neighbors table based on data read from incoming LLDP

advertisements.

For example, to disable LLDP on the switch:

ProCurve(config)# no lldp run

Changing the Packet Transmission Interval. This interval controls how

often active ports retransmit advertisements to their neighbors.

Syntax [ no ] lldp run

Enables or disables LLDP operation on the switch. The no form

of the command, regardless of individual LLDP port

configurations, prevents the switch from transmitting outbound

LLDP advertisements, and causes the switch to drop all LLDP

advertisements received from other devices. The switch

preserves the current LLDP configuration when LLDP is

disabled. After LLDP is disabled, the information in the LLDP

neighbors database remains until it times-out. (Default:

Enabled)

Syntax lldp refresh-interval < 5 - 32768 >

Changes the interval between consecutive transmissions of

LLDP advertisements on any given port. (Default: 30 seconds)

Note: The refresh-interval must be greater than or equal to

(4 x delay-interval). (The default delay-interval is 2). For example,

with the default delay-interval, the lowest refresh-interval you can

use is 8 seconds (4 x 2 = 8). Thus, if you want a refresh-interval of

5 seconds, you must first change the delay interval to 1 (that is,

4 x 1 < 5). If you want to change the delay-interval, use the setmib

command.

1 2 ... 334 335 336 337 338 339 340 341 342 343 344 ... 588 589

Comentários a estes Manuais

Sem comentários

HP PROCURVE 6120 Manual do Utilizador Página 339

Comentários a estes Manuais

Manuais e produtos relacionados com Software HP PROCURVE 6120