HP Remote Graphics Software (RGS) Manual do Utilizador Página 147

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 146
6.5.1 Attaching a local USB device to a Remote Computer
The options available under the USB tab in the Receiver Control Panel are shown in Figure 6-15 USB
tab options on page 129.
Figure 6-15 USB tab options
The USB options are:
Enable Remote USB—This checkbox can be used to dynamically (during an active RGS
connection) enable or disable USB connections to the Remote Computer. When enabled, USB
devices plugged into the Local Computer appear to the Remote Computer as locally attached
devices. Because remote USB supports hot plug connections, it is not necessary to disable remote
USB before plugging or unplugging USB devices on the Local Computer.
Select sender—If multiple Remote Computers are specified in Directory Mode, the Select sender
drop down menu is used to select which Remote Computer (Sender) receives the remote USB
connection. In
Figure 6-14 USB configuration during Receiver installation —USB devices are Local
or Remote on page 128, the RGS Receiver is operating in Directory Mode and the Remote
Computer at IP address 10.10.42.65 is selected to receive the remote USB connection.
NOTE: Directory Mode operation is discussed in Using Directory Mode on page 162.
Figure 6-16 Prior to remote attachment of the USB drive key on page 130 shows the presence of the
USB drive key on the Local Computer before the remote USB attachment is made.
ENWW
Remote USB operation
129
Vista de página 146
1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 258 259

Comentários a estes Manuais

Sem comentários