HP Remote Graphics Software (RGS) Manual do Utilizador descarregar pdf (Página 76)

CAUTION: Adjusting the process priority of the Sender to a level higher than –normal can cause

other normally privileged processes to receive fewer CPU cycles than normal. Therefore, caution should

be observed in adjusting the priority of the Sender.

3.1.2.7 Setting the Sender process priority using PTF

The HP Performance Tuning Framework (PTF) can be used adjust the priority of the Sender without

having to use regedit. PTF is available for HP Workstations only from this location:

http://www.hp.com/workstations/software/framework/index.html

See the PTF help and documentation for further information.

3.1.2.8 Using the rgadmin tool

NOTE: The rgadmin tool is only installed and supported on Windows XP.

This section describes use of the Sender rgadmin.exe tool. For a normal Sender installation, this tool

can be found at:

C:\Program Files\Hewlett-Packard\Remote Graphics Sender\rgadmin.exe

When run, the rgadmin.exe program displays two tabs. The 3D Updates tab (see

Figure 3-11 3D

Updates tab on page 60) can be used to enable automatic 3D updates from the application to the

Sender. These updates inform the Sender what screen rectangles have been changed by the 3D

application.

Figure 3-11 3D Updates tab

NOTE: RGS versions prior to RGS 4.0 required the manual placement of the RGS OpenGL32.dll

library into the application directory for each application. For RGS 4.0 and later, this library may

cause applications to fail on startup. Because automatic updates of OpenGL applications are now

supported, the OpenGL32.dll library is no longer required, and should be removed from any

application directories where it resides.

60 Chapter 3 Installing RGS ENWW

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 242 243

Sem comentários

HP Remote Graphics Software (RGS) Manual do Utilizador Página 76