HP Vectra VE5 2 Guia do Utilizador descarregar pdf (Página 68)

If the Hard Disk Activity Light Does Not Work

If the hard disk activity light does not flicker when the PC is accessing the hard disk drive:

• Check that the control panel connector is firmly attached to the system board.

• Check that the disk power and data cables are correctly connected.

NOTE If you are using a hard disk drive with a controller

board (a SCSI hard disk, for example), the activity

light does not flicker when the PC is accessing the

hard disk drive

IF THE CD-ROM DRIVE DOES NOT WORK

• Check that the cables have been properly connected.

• Check that a CD is inserted in the drive.

• Verify that the CD-ROM is declared as “CD” in the

Setup

program on the Hard Disk

Drives menu.

• Verify that the On-board Bus IDE Adapters item is set to Both in

Setup

• If you intend to boot on CD-ROM, make sure that this option is enabled in

Setup

on the

Security menu.

• For further information refer to the CD-ROM documentation.

IF AN ACCESSORY BOARD DOES NOT WORK

Carry out the following checks:

• Ensure the board has been firmly installed in the accessory board slot.

• Check that the accessory board has been correctly configured with the ISA Configuration

Utility if necessary.

• Ensure the board is not using memory, I/O addresses, an IRQ, or DMA also used by the

PC. Refer to “IRQs, DMAs, and I/O Addresses Used by Your PC” in chapter 6. Refer to

the board’s manual for further details.

When using Windows 3.11, you can obtain information about the current use of IRQs by

the PC by typing MSD at the MS-DOS prompt, and pressing [ENTER]. If you are using

Windows 95, use the Device Manager.

• Check that the PC has been configured correctly in

Setup

• If the problem persists, refer to chapter 7, Hewlett Packard Support and Information

Services, for information about where to obtain support.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 101 102

Sem comentários

HP Vectra VE5 2 Guia do Utilizador Página 68