HP Vectra VE5 2 Guia do Utilizador descarregar pdf (Página 69)

IF YOUR PC HAS A SOFTWARE PROBLEM

If You Have Forgotten Your Password

• If you forget the User Password, but not the Administrator password, carry out the

following procedure:

1 Restart the PC. If the keyboard is locked, unplug the power cord and plug it in again.

2 Wait for F2=Setup to be displayed.

3 Press [F2] to start

Setup

4 Enter the Administrator Password to access the Preferences menu.

5 Move to the User Password field and set a new User Password. This will replace the

old password which you had forgotten.

6 Press [F3] to save the new Password and exit

Setup

• If you forget both the User Password and the Administrator Password:

1 Switch off the PC.

2 Remove the computer’s cover.

3 Set switch 5 (PASWD EN) on the system board switch block to CLOSED.

4 Switch on the PC and allow it to complete its startup routine.

The message “Passwords have been cleared, power-off your PC and

set switch 5 to open position before restarting” will be displayed.

5 Switch off the computer.

6 Reset switch 5 (PASWD EN) to OPEN.

7 Replace the computer’s cover.

8 Switch on the PC and allow it to complete its startup routine.

9 After the Power-On Self-Test has completed, press [F2] when prompted to use

Setup

10 Set new User and System Administrator Passwords.

11 Press [F3] to save the new passwords and exit

Setup

IF YOUR APPLICATION SOFTWARE DOES NOT WORK

If the PC reports the system is OK and the indicator light over the power switch is illuminated,

but some software won’t run:

• Check to see if the AUTOEXEC.BAT file is present with the correct settings (Windows

3.11 only). Refer to the operating system and application software manuals.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 101 102

Sem comentários

HP Vectra VE5 2 Guia do Utilizador Página 69