Hp 3PAR Operating System Software Manual do Utilizador descarregar pdf (Página 31)

Default CPGs

The setup process automatically creates default CPGs on your HP 3PAR StoreServ 7000

Storage system. The CPGs that are created depend on your HP 3PAR storage system’s drive

types, number of drive cages, and RAID types, as described in the following table.

Default CPG CreatedRAID TypeDrive Type

FC_r11Fast Class

FC_r66Fast Class

NL_r11Nearline

NL_r66Nearline

SSD_r11Solid State

SSD_r55Solid State

SSD_r66Solid State

Using Default CPGs

• To use SmartStart to create basic storage, assign the default CPG to the virtual volumes

you create.

• To create a new CPG, install and use the HP 3PAR Management Console (see SmartStart

wizard step 7, Install the HP 3PAR Management Console).

3. Export virtual volumes. When you export (present) virtual volumes to a host, you make the

volumes accessible to the host. The host system can then perform read/write operations on

the exported virtual volumes on your HP 3PAR storage system.

4. Configure virtual volumes. In addition to creating storage, you must configure the exported

virtual volumes on your Windows Server 2008 R2 or Windows Server 2012 host system so

the host system can use these volumes. The Add Virtual Volumes to Windows wizard, accessed

from SmartStart wizard step 6, Configure storage, guides you through configuring virtual

volumes on a Windows Server 2008 R2 or Windows Server 2012 host system.

For more information about creating storage or to set up advanced storage parameters, use the

HP 3PAR Management Console. To install the HP 3PAR Management Console, go to SmartStart

wizard step 7, Install the HP 3PAR Management Console.

NOTE: If SmartStart detects that you are using Windows 7 or Windows 8, the Add virtual volumes

to Windows link on step 6, Configure storage is disabled. For more information on adding virtual

volumes, refer to the HP 3PAR Windows Server 2012 and Windows Server 2008 Implementation

Guide.

Create Hosts

Welcome to the Create Host Wizard

The Welcome screen describes the settings and properties you can assign to a host.

NOTE: If you click to select the Click here to skip this step in the future checkbox and later want

to reinstate the Welcome screen, delete the following file:

C:\Users\<username>\SmartStart\preferences\preferences.xml

Create Hosts 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 60 61

Sem comentários

Hp 3PAR Operating System Software Manual do Utilizador Página 31