Hp Hitachi Dynamic Link Manager Software Manual do Utilizador Página 223

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 222
3. Creating an HDLM Environment
199
multipath=off
initrd /initrd-2.6.16.60-0.54.5-smp
multipath=off
is set in the underlined section.
3. Check whether the definition in the
/etc/fstab file contains LABEL.
Check the contents of the
/etc/fstab file.
Figure 3-8: Example Content of /etc/fstab file When using LVM2 shows example
content of
/etc/fstab file.
Figure 3-8: Example Content of /etc/fstab file When using LVM2
LABEL is set in the shaded portion.
This example assumes that IA32 uses
GRUB as the boot loader. When you use IPF
that uses
ELILO as the boot loader, the mount point is displayed as /boot/efi
instead of
/boot (in the line where /boot is coded), and the file system type is
displayed as
vfat instead of ext3.
If
LABEL is not used in the /etc/fstab file, go to step 10 and install HDLM. If
LABEL is used in the /etc/fstab file, perform steps 4 to 8 to check the mounted
file system, and then remove the
LABEL setting.
4. Execute the
mount command to check the mounted file system.
Check the correspondence between the SCSI device and
LABEL that you checked
in steps 3. You will need this information to remove the
LABEL setting.
Figure 3-9: Example of Executing the mount Command shows an example of
executing the
mount command.
Vista de página 222
1 2 ... 218 219 220 221 222 223 224 225 226 227 228 ... 745 746

Comentários a estes Manuais

Sem comentários